| Item |
Characteristics |
| Operating Temperature Range |
-40 to +105°C |
| Rated Voltage Range |
6.3 to 50VDC |
| Capacitance Range |
0.1 to 100µF |
| Capacitance Tolerance |
±20% (M) at +20°C, 120Hz |
| Leakage Current |
I = 0.01CV or 3µA, whichever is greater, after 2 minutes at +20°C.
Where I = Leakage current (µA), C = Nominal capacitance (µF) and V =
Rated voltage (V) |
| Dissipation Factor (Tan d) |
At +20°C, 120Hz
| Rated Voltage (V) |
6.3 |
10 |
16 |
25 |
35 |
50 |
| Size 04-06.3 |
0.3 |
0.24 |
0.2 |
0.16 |
0.14 |
0.12 |
| Size 08 & 010 |
0.4 |
0.3 |
0.26 |
0.16 |
0.14 |
0.12 | |
| Low Temperature Characteristics |
At 120Hz, impedance (Z) ratio between the -25°C or -40°C value and
+20°C value shall not exceed the values given below.
| Rated Voltage (V) |
6.3 |
10 |
16 |
25 |
35 |
50 |
| Z (-25°C)/Z (+20°C) |
4 |
3 |
2 |
2 |
2 |
2 |
| Z (-40°C)/Z (+20°C) |
10 |
8 |
6 |
4 |
3 |
3 | |
| Load Life |
The following specifications shall be satisfied when the capacitors
are restored to +20°C after subjecting them to the DC rated voltage for
the specified test time at +105°C. The sum of DC voltage and peak AC
voltage must not exceed the full rated voltage of the capacitors.
Size 04-06.3: 1,000 hours
Size 08 & 010: 2,000 hours
Capacitance change :
Size 04-06.3 : <= ±30% of the initial
measured value
Size 08 & 010 : <= ±20% of the initial measured
value
Tan d (DF):
Size 04-06.3 : <= 300% of the initial specified
value
Size 08 & 010 : <= 200% of the initial specified
value
Leakage current : <= initial specified value |
| Shelf Life |
The following specifications shall be satisfied when the capacitors
are restored to +20°C after exposing them for the specified test time at
+105°C without voltage applied. The rated voltage shall be applied to the
capacitors for a minimum of 30 minutes, at least 24 hours and not more
than 48 hours before the measurements.
Size 04-06.3: 500 hours
Size 08 & 010: 1,000 hours
Capacitance change :
Size 04-06.3 : <= ±25% of the initial
measured value
Size 08 & 010 : <= ±20% of the initial measured
value
Tan d (DF): : <= 200± of the initial specified
value
Leakage current : <= initial specified value |
| Others |
Satisfies characteristic W of JIS C5141 |
